|
|
Assembling Raised Garden Beds
|
70mm Posidrive Screws
x2 Base Side Panels
x2 Base End Panels
x2 Top Side Rails
|
Suggested assembly tools-
Electric drill or hand held screwdriver,
Tapemeasure.
Stage 1 - Base assembly
|
|
Screw end panels to side panels using 70mm screws through the pre-drilled holes, ensuring both end and side go together without gaps.
|
|
(Tip) using your tape measure, check that corner to corner diagonal measurements are equal. This ensures that the bed has been screwed together square prior to fixing the top on.
Base complete
Stage 2 - Top assembly
|
|
Stage 3
Place assembled top onto base, using a tape measure ensure that the underneath overhang (from the side of the base to the outside edge of the top) is equal around all four sides of the base.
(Note) If installing a liner, now is the time to fit this as you trap the liner under the top. To give a neat finish.
Step 4
When overhang is equal on all four sides, screw down top to base using 70mm screws through pre-drilled holes, this completes your raised garden bed.
|
|
|
